E-Locker for Ford 8.8 - Electronic Locker, NO AIR COMPRESSOR NEEDED!
|
Fits Ford 8.8 31-spline axles (3.73 and up) - COMES WITH CABLE!!
|
Fits 87-06 Dana 30 Axles with 27 splines axles (Stock axles), 3.73 to 5.38 Gears
|
Fits Dana 30 30-spline axles (3.73 and up) - COMES WITH CABLE
|
Fits Dana 35 30-spline axles (3.55 and up) - COMES WITH CABLE
|
Fits: 1990-02 Dana 35 axle with C-clips - 30 spline Upgrade
|
Fits 87-06 Dana 35 Axles with 27 splines axles (Stock axles), 3.54 to 5.38 Gears
|
Fits: Super 35 Truss kit 97-06 Dana 35
|
Fits: Dana 44 with 3.92 to 5.38 Gears - This is the OFFICIAL 100% Lockup Detroit Locker
|
Fits Dana 40 30-spline axles (3.92 and up) - COMES WITH CABLE
|
Dana 44 Super Truss by Superior Axle and Gear
|
Replace your factory CV axle with this stonger and longer lasting alloy axle kit. This kit is the BEST way to get an ARB air locker into your WJ Dana 30!!
|
Convert your ball in socket Saginaw front driveshaft to a U-joint style C.V. driveshaft
|
Polyurethane Engine Mounts for your I6 XJ - backed by a lifetime warranty!
|
Fits: 27 Spline C Clip Dana 30 with 3.73 and Numerically Higher Gear Ratio
|
Fits: 30 Spline C Clip Dana 30 with 3.73 and Numerically Higher Gear Ratio
|
Fits: 27 Spline C Clip Dana 35 with 3.54 and Numerically Higher Gear Ratio
|
Fits: 30 Spline C Clip Dana 35 with 3.54 and Numerically Higher Gear Ratio
|
Jeep ZJ, XJ AXLE BRACKET KIT - Swapping in a new FRONT axle?.... This is the kit you need - Spring Buckets, shock mounts, control arm mounts...etc
|
Heavy Duty Stock Height Motor Mounts for your I6 XJ or MJ!!
|
Flange Spacer so you can run WJ brakes and Steering on your XJ or ZJ!
|
Fits: Dana 35 27 Spline Open Carrier Lock Right Locker by Powertrax for Jeep Cherokee XJ 1994-97 or 93-98 Jeep Grand Cherokee ZJ
|
Adjustable Cross-Over Shock mount - Allows 3" more axle travel
|
Superior Axle & Gear Super 88 kit for Ford 8.8 axle
|
Fits NP231 and NP242 transfer cases in XJ and ZJ's
|
Fits NP231 and NP242 transfer cases in XJ and ZJ's - PRE 96
|
SYE KIT, HEAVY DUTY NP231 ONLY - This kit includes the entire new output shaft, tail housing and yoke.
|
Fits 96+ Jeep ZJ, XJ with NP231 OR NP242 transfer case KIT COMES WITH DRIVESHAFT!!
|
XJ front axle Lower control arm brackets - 3/16 thick - Direct replacement!
|
Steel 4 Degree Shims - If your doing an axle swap or a big suspension lift, these are a must!
|